PDA

View Full Version : Starting Motor D2 / D4 - Rods next to Magneto



Cat-astrophe
11-10-2019, 02:48 PM
Hello
I am rebuilding a starting motor out of a D2. It has two hollow tubes that install on either side of the magneto. I haven't been able to find a reference to these in the D2 / D4 parts book. Would appreciate if someone could let me know the reference for these. I have checked the HT4 parts book thinking they might support the cut away dash - but cant find a reference there. Have found a couple of pics on the web where these are also installed. Thanks

Rome K/G
11-10-2019, 03:12 PM
Those are for the spark plug wires to run through. Part# is 2B8491 I think it is sold by the cm.

STEPHEN
11-10-2019, 03:24 PM
Not the two tubes that support the intake manifold from the air cleaner?

Neil
11-10-2019, 03:28 PM
As Stephen wrote. I had to build up the manifold area where one of them sat as it had been loose and had wallowed out

Old Magnet
11-10-2019, 05:37 PM
Support tubes for the air intake pipe. Part #5F8314. I believe they are just 1/4" trade size pipe.

Rome K/G
11-10-2019, 05:41 PM
Ok, I was thinking "tubes" not supports.

Neil
11-10-2019, 07:45 PM
But he does also need the tubes that Rome referenced for a good clean installation too. Nicely tidies up the plug wire routing