Looking for a working not worn out machine I can use around my little place. I would like to find one with a toolbar hydraulic blade but that’s not a deal killer. I would prefer to find one fairly close but would look at the right one further away from (98948) shipping can be a real pain. I had a TD6 that I was using working on and once I got the old grease off the final drive housings found they were broken so bad I had to scrap the machine and it was a bit to small for me as well. Thanks guys

Ross

considering a D2 as well, I saw a few of these old girls around when I was not looking, not sure where they all went.

(edit) also started looking for an allis chalmers HD5, going to buy a machine this year (soon) I have some things I want to play with and have a little extra cash atm so things are getting serious lol

I have a D4 7U 17655.... 1952 model. Tool bar dozer blade. Starts, runs and operates as it should. Above average condition for its age. have all the books including service manual. Two issues with the machine. Crankshaft seal on pony motor leaks oil and will need to be replaced. Also main engine wll miss on one cylinder when under hard push. I was told the valves need adjusted. I have the valve cover gasket but haven't done the work.

I am located in the Nebr. panhandle, 170 miles east of Cheyenne,Wy on I-80. Price $6000. Call or text 308-289-5881

still looking

still looking

Does a Great Running Allis Chalmers HD6B interest you? Tilt blade. In Michigan

hello, I think I am going to stick to Caterpillar. thanks tho.

I have an RD4 runner, good running pony, blade, rear winch, some work done, good undercarriage. Norcal, $2,200.