acmoc

ACMOC Membership Benefits

  • FREE quarterly magazine filled with content about antique Caterpillar machines
  • FREE classified listings
  • ACMOC store discounts and specials
  • Full Bulletin Board Access
    • Marketplace (For Sale/Wanted)
    • Technical Library
    • Post attachments

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

PROBLEM with Carburator Cat D2 J series

More
16 years 10 months ago #12884 by novavalleycat
Concerning the non adjustable idling jet, no.18 in the manuel... this controls the amount of fuel taken from the high speed metering well...this brass tube is broken off 3\16 ahead of the threads ,how is one going to get this out.
:confused: Nova Valley Cat

Please Log in or Create an account to join the conversation.

More
16 years 10 months ago #12885 by Mike Mahler
If the tube is pressed in you may be able to thread a small screw into the tube and perhaps be able to turn it out. OR, you can take a small ball burr on a dremal tool and go inside the tube and relieve it just enough to ease the tension on the tube (Do not grind into the carb housing!) the pick the tube out where you have ground. good luck and take it slow.
Mike

My services shown at www.myspace.com/vintageengine

Please Log in or Create an account to join the conversation.

More
16 years 10 months ago #12899 by novavalleycat
Replied by novavalleycat on topic Thank You Mike Mahler
Thank You for your help ,I will try it. Nova Valley Cat

Please Log in or Create an account to join the conversation.

Time to create page: 0.154 seconds
Go to top