acmoc

ACMOC Membership Benefits

  • FREE quarterly magazine filled with content about antique Caterpillar machines
  • FREE classified listings
  • ACMOC store discounts and specials
  • Full Bulletin Board Access
    • Marketplace (For Sale/Wanted)
    • Technical Library
    • Post attachments

$44 /year ELECTRONIC

$60 /year USA

$77 /year International

D13000

More
15 years 10 months ago #17652 by charles poole
D13000 was created by charles poole
Hi all , can anyone give me the flywheel to crank bolt torque specs for a 13000 engine ? thanks,
Charles

Please Log in or Create an account to join the conversation.

More
15 years 10 months ago #17655 by SJ
Replied by SJ on topic Torque
Just get a torque sheet and check the size bolt and go by that torque on the sheet. If I remember right they are a 3/4" bolt so 225 lbs. torque would be good if they are 3/4" but check the diameter anyway to be sure.Go to that torque and advance enough so the lock bend overs line up ok.

Please Log in or Create an account to join the conversation.

More
15 years 10 months ago #17659 by charles poole
Replied by charles poole on topic D13000
thanks SJ , will talk to you soon ,
regards ,
Charles

Please Log in or Create an account to join the conversation.

More
15 years 10 months ago #17679 by Old Magnet
Replied by Old Magnet on topic D13000
Hi Charles,
This may be coming at you a little late but here's the chart on standard bolt torques.

Please Log in or Create an account to join the conversation.

Time to create page: 0.134 seconds
Go to top