Hi I require the following parts to suit a caterpillar twenty two.

P/N L897 - PLATE (this is the top cover plate for the gear shift and steering clutch levers that bolts to the transmission housing.)

P/N 2B 2075 - LEVER (the external governor lever that clamps to the governor output shaft)

P/N 2B 6868 - SHAFT (the water pump drive shaft) or a supplier of 9/16" chrome rod 12" long.


Any help appreciated.
Nolan Sheehan
email <a href="This email address is being protected from spambots. You need JavaScript enabled to view it." target="_blank">This email address is being protected from spambots. You need JavaScript enabled to view it.

A better choice for the water pump shaft would be stainless steel shaft if you can find it.

I have the lever and the plate, should have the water pump shaft also. If your still looking. Scott

Thanks for the replys. This is a photo of the 22 in my shed after recovering it from the rain forrest on a local sugar cane farm where it was used from new untill being abandoned. It was covered in old roofing iron untill cyclone Lary blew it away in 2006. Steel rusts fast in our wet climate so most of the pannels need replacing. I will most likely need more parts once it is fully stripped and assesed. The brake and clutch compartments have had water in them at some stage but hoping it's all recoverable.

Best of luck with your restoration. Keep us posted on your progress.

Nolan, I have a hood, tank, seat box and fenders that might do you good. Cheers, Scott